PARALLELS CLIENT CONNECTION INSTALL

In the Authentication type drop-down list, select the desired method of authentication:.The button next to the Primary Connection field allows you to select a Parallels RAS server (this will only work if the Broadcast RAS Secure Client Gateway Address option has been enabled on the server side).You can also review and modify other properties if you wish.Specify the port number in the Port field.The Connection Properties dialog opens (see the screenshot below). If your system administrator told you to specify the port number, do the following:.In the Friendly name field, choose and type a friendly name for this connection.Same as the gateway mode above, but uses encryption to secure the data. This mode is ideal for servers that are only reachable via the gateway and do not require a high level of security. Parallels Client connects to the RAS Secure Client Gateway and the session connection is tunneled through the first available connection. Same as the direct mode above, but uses encryption to secure the data. This is best used when the Parallels Client and the terminal server reside on the same network. Parallels Client first connects to the RAS Secure Client Gateway for the best available terminal server and then connects directly to that server. In the Connection mode field, select one of the following options (note that you should use the mode that your system administrator has asked you to use):.In the Server field, enter the Parallels Remote Application Server IP address or hostname (this should be the server where the RAS Secure Client Gateway resides).To manually configure the RAS Connection, use the following settings: The information will look similar to the following: If you received an invitation email from your administrator, you can find this information at the bottom of the message. Your system administrator should give you the connection information that must be specified in this dialog. This will open the New connection dialog.

PARALLELS CLIENT CONNECTION INSTALL

Connecting to Parallels Remote Application ServerĪfter you manually install Parallels Client and run it for the first time, you'll be asked if you would like to configure a new connection.

Parallels client connection